Olympia Blends Products and Services LLC

THIS CONCESSION INCLUDES THE FOLLOWING:

• 8 ½ x 28 Wide Body Wells Cargo Concession Trailer
• 8” x 3” rectangular steel tube main rails
• 6000 LB 10 degree up Torflex axles with 12” x 2” electric brakes
• ST235/80R16 load range ‘D’ radial tires mounted on a 8 bolt electro deposition coated silver spoke wheel
• Two - 15000 BTU roof top A/C units
• 7 ½ ’ inside height, 84 ¾ vertical posts located on 16”  centers
• NSF approved stainless steel deep 3 compartment sink with faucet and drain board on each side (fully enclose sink assembly with cabinet enclosure)
• Separate stainless steel hand sink with faucet and cabinet enclosure with self latching door
• Removable laminated counter to place over 3 sink compartments (gives you additional prep space)
• Heavy duty on demand water pump with on/off wall switch (located under the sink assembly)
• 6 gallon hot water heater (located under the sink assembly)
• 25 gallon fresh water tank (located under the sink assembly)
• External water hook up to easily fill your water tank (located outside the trailer)
• 34 gallon waste water holding tank (located under the concession just below the sink assembly to meet health code requirements)
• A dump valve for easy waste removal (conveniently located outside the unit)
• 100 Amp, 120/240v panel box w/100 Amp main breaker and raceway through floor for electrical connection (shoreline power cord not included)
• One 15 amp GFI duplex wall outlet
• Eleven 15 amp duplex outlet wall outlets
• Six – 4’ double fluorescent light fixtures with on/off wall switch and diffuser covers (bulbs not included)
• Jack ram hoist w/sand pad (raises and lowers tongue)
• Standard three piece A-Frame (tongue)
• Deck A-Frame with aluminum tread plate
• 4 scissor type stabilizer jacks for stability (locate on each corner)
• ¼” white vinyl plywood interior sidewall liner
• Full width ceiling lined with ¼” white vinyl covered plywood contoured to roof radius (includes lining end caps)
• 1 5/8” ceiling insulation
• Aluminum diamond tread plate over standard plywood floor (Note: caulk seam between floor and sidewall before installing floor molding)
• ¾” exterior grade plywood floor, exterior surface undercoated, interior surface painted gray
• Two - 36” W x 80” H pre-framed entry doors with screen, RH hinge with knob lock, and dead bolt (locate on front and rear)
• Two - 30" x 26" radius tinted glass window with horizontal slider windows
• Chassis fully undercoated with RPC (rust proof undercoating)
• Weather resistant wiring where applicable
• 2 5/16" top mount coupler with replaceable locking dog assembly
• D.O.T. “A” Frame mounted 22 amp hour UI series battery, breakaway switch, aluminum mounting bracket, cover, battery “charge” indicator and diode isolation
• Seven way trailer end connector
• S.A.E. color coded 12v electrical system, exterior running light package
• 5/16" safety chains with Clevis safety slip hooks and latch to D.O.T. standards
• .030 pre-finished BLACK smooth exterior aluminum installed vertically with non corrosive mechanical fasteners
• Platform for propane tank assembly
• Double 40 LB propane bottles with auto changeover regulator and mounting bracket
• Three - 14” x 14” screened translucent roof vents with crank
• Laminated permanent inside counter (color: white, build 24” deep x approx. 109” long – install along roadside wall)
• Laminated permanent inside counter (color: white, build 30” deep x approx. 131” long – install along curbside wall -  counter height must be 37” high to accommodate under counter refrigeration/freezer unit)
• 28”  deep x approx. 56” long base cabinet with white Formica top, self latching  cabinet doors, and one inside shelf (install along curbside wall)
• Install 4-6 each 3” sections of “C” channels and install reinforced roof bows for 128” hood
• Installation of a 128” hood system and exhaust fan
• On/off wall switch for hood system exhaust fan 

THIS CONCESSION ALSO INCLUDES THE FOLLOWING EQUIPMENT:

• NSF APPROVED 128” long commercial hood system with grease extracting exhaust fan, UL listed
• NSF APPROVED 19 cu. ft. stainless steel commercial stand up freezer, True model T-19F
• Two - NSF APPROVED 19 cu. ft. stainless steel commercial stand up refrigerator, True model T-19
• Two - NSF APPROVED commercial stainless steel 23 cu. ft. hot holding cabinets, True model, TH-23 
• NSF APPROVED 36” long stainless steel equipment stand with an adjustable underneath shelf
• NSF APPROVED 36" commercial LP char broiler
• NSF APPROVED commercial two basket LP fryer
• NSF APPROVED stainless steel commercial LP six burner range with full oven
• NSF APPROVED LP double deck convection with full oven manufactured by Moffatt, model #G32MS/2
• NSF APPROVED 6.5 cu. ft. stainless steel commercial under counter refrigerator, True model, TUC-27
• NSF APPROVED 6.5 cu. ft. stainless steel commercial under counter freezer, True model, TUC-27F
• Soap dispenser
• Towel rack
• Two commercial ABC fire extinguisher
• If applicable, ring style wall mounted tie downs to secure non permanently mounted equipment (includes ratchet type tie downs 1000 LB capacity)
• 128” stainless steel backsplash behind the cooking equipment
• Run LP gas lines from changeover regulator on LP tanks to cooking equipment

If this concession doesn't suit your needs, give us a call and we'll design one that does...1-813-657-9211.